18.42.060 Monuments.

The following monuments shall be installed to the satisfaction of the city engineer:

(A) Permanent iron pipe monuments of a type approved by the city engineer shall be set at each boundary corner of the subdivision, along exterior boundaries at intervals of not over five hundred feet, at the beginning and end of property line curves, and at any other points as may be required by the city engineer.

(B) Concrete monuments depressed below street grade with cast iron ring and cover of a type approved by the city engineer shall be set at intersections of street center line tangents or offsets therefrom, and where such intersect on private property, at the beginning and end of centerline curve and/or offsets therefrom. The exact location of all such monuments shall be shown on the final map before approval is requested.

(C) Any monument or bench mark, as required by this code, that is disturbed or destroyed before acceptance of all improvements shall be replaced by the subdivider.

(D) Monuments and bench marks shall be set before acceptance of all improvements by the city council.

(E) A three-quarter inch pipe eighteen inches long, visibly marked or tagged with the registration number or license number of the civil engineer or land surveyor under whose direction the survey was made, shall be placed at the front corners of each lot or set in lieu thereof a permanent mark shall be made or set on the top of the concrete curb along with prolongation of the side lot lines of the lot to the street.